Water Gem System With Heavy Duty Ceramic Valve Tap

Premier Water Gem Pack with Heavy Duty Tap and Extra Filter

Water Gem under-sink filter system kit with an extra filter and premium heavy duty ceramic faucet tap.

Our Premium Water Gem Kit includes a high quality twist turn action ceramic tap designed to complement your kitchen. For extra convenience the Premium Water Gem Kit also contains an extra filter ready for replacement in 6 months time.

Made in Southport in the UK for over 20 years from WRAS approved materials, the Watergem offers a cost effective, reliable and easy to fit alternative to bottled water and a filter jug. The Water Gem is also kinder to the environment than bottled water as it accrues less carbon debt and results in far less waste plastic going to landfill.
 
Providing fresh, bottled quality water from a dedicated tap in your kitchen, the Water Gem comes with everything needed for an easy D.I.Y installation.

• Six month filter life
• Easy D.I.Y installation
• Built-in scale inhibitor
• Constructed from WRAS approved materials
• Reduces chlorine taste & odour
• An alternative to buying in bottled water and helping with the environmental fight against plastic pollution. The system also helps reduce any microplastics in your drinking water.

It is quite easy to fit this system yourself. A lot of people are under the misconception that they would need a plumber to fit the system which is not the case. The saddle valve that makes the connection from your cold water pipe is self- piercing and can be easily fitted yourself using the below instructions.

   Full instructions are provided with the system

 Identify the mains cold water pipe, using a section that is straight and free from paint, scratches or dents. Connect the saddle valve to the cold-water pipe. Finger tighten the clamp by turning the bottom nut. Then tighten properly with a spanner. DO NOT OVER TIGHTEN. One or two spanner turns after finger tight should do. The aim is simply to make the saddle valve immovable on the pipe.

 Once saddle clamp is secured firmly on the pipe, turn the T bar tap on the saddle clamp clockwise until is stops turning. (This will pierce the pipe with a metal pin – invisibly). Turning the T bar tap a few turns back will allow the water flow. Only do this when you are ready to ‘start up’ the system.

The Faucet tap is also straight forward to fit by following the below instructions.

Select a position for the tap on the counter or sink shoulder, you may already have a removable cap that will reveal a hole for your tap. The faucet should be located in a position that gives a flow of water into the sink bowl. Ensure (check) that you have enough room below the desired position to connect the tubing to the tap. Using a centre pop (or nail) mark where the centre of the tap stud will be and drill a 12mm hole through the surface. Secure the tap in place by using the fixing kit provided.

Carriage is free of charge to UK mainland.