Water Gem II Full System with Heavy Duty Chrome Tap

Water Gem II Full System with Heavy Duty Chrome Tap

Full system including installation kit, tap, 1 x filters, filter head and heavy duty chrome tap.

The latest upgrade to the Water Gem comes in the shape of the Water Gem II which was featured on QVC on it's launch. We are an approved distributor for the manufacturer Aqua Cure and this product is fast becoming a top choice for an easy to install domestic water filter.

1 micron filtration for finer filtration and cyst rated performance makes the system a higher standard than the original Water Gem system.

The system also features a wide reach swan neck tap with a continuous flow function.

The Water Gem II filter has been designed to use 53% less plastic than it's predecessor while the capacity has actually increased due to new internal technology making the filter a much environmentally friendly proposition which results in much less waste plastic.

The system comes with full D.I.Y install kit and faucet tap for an easy install while the twist-fit head makes filter changes easy with no tricky push-fit fittings.

• Six month filter life
• Easy D.I.Y installation
• Built-in scale inhibitor
• Constructed from WRAS approved materials
• Reduces chlorine taste & odour
• Quick change filters - change a filter in seconds
• This system represents an alternative to buying bottled water, thus reducing plastic pollution.
• The system reduces microplastics in your drinking water down to 1 micron.
• The system is also known as the WaterGem 2 system.

It is quite easy to fit this system yourself. A lot of people are under the misconception that they would need a plumber to fit the system which is not the case. The saddle valve that makes the connection from your cold water pipe is self- piercing and can be easily fitted yourself using the below instructions.

   Full instructions are provided with the system

 Identify the mains cold water pipe, using a section that is straight and free from paint, scratches or dents. Connect the saddle valve to the cold-water pipe. Finger tighten the clamp by turning the bottom nut. Then tighten properly with a spanner. DO NOT OVER TIGHTEN. One or two spanner turns after finger tight should do. The aim is simply to make the saddle valve immovable on the pipe.

 Once saddle clamp is secured firmly on the pipe, turn the T bar tap on the saddle clamp clockwise until is stops turning. (This will pierce the pipe with a metal pin – invisibly). Turning the T bar tap a few turns back will allow the water flow. Only do this when you are ready to ‘start up’ the system.

The Faucet tap is also straight forward to fit by following the below instructions.

Select a position for the tap on the counter or sink shoulder, you may already have a removable cap that will reveal a hole for your tap. The faucet should be located in a position that gives a flow of water into the sink bowl. Ensure (check) that you have enough room below the desired position to connect the tubing to the tap. Using a centre pop (or nail) mark where the centre of the tap stud will be and drill a 12mm hole through the surface. Secure the tap in place by using the fixing kit provided.

 1 X WG62, 1 X ACSVCV5, 1 X ACT142 AND 1 X ACLRFT16 

Carriage is free to UK mainland.